Author Topic: Find and Replace does not work  (Read 171 times)

Offline kbumm

  • Newcomer
  • *
  • Posts: 17
    • View Profile
Find and Replace does not work
« on: January 05, 2021, 05:05:20 AM »
Hello,
the "find and replace" tool does not work.
An error message appears (look at the image)
I can't say whether it has worked before or not because I had PM5 before PM6.
The original picture I wanted to search through "find and replaced" is attached.

Regards
Jürgen

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 22288
    • View Profile
    • Camera Bits, Inc.
Re: Find and Replace does not work
« Reply #1 on: January 05, 2021, 01:19:29 PM »
Jürgen,

the "find and replace" tool does not work.
An error message appears (look at the image)
I can't say whether it has worked before or not because I had PM5 before PM6.
The original picture I wanted to search through "find and replaced" is attached.

I'm able to find and replace (it replaced two occurrences) with your sample image.  See the attached image below.  I am also using build 5404.  Could you make a snapshot of your Find and Replace settings and post it here?  It may be that my settings aren't quite the same (not all of the checkboxes were visible.)

Thanks,

-Kirk

Offline kbumm

  • Newcomer
  • *
  • Posts: 17
    • View Profile
Re: Find and Replace does not work
« Reply #2 on: January 05, 2021, 02:39:00 PM »
Hello Kirk,

I don't understand what the problem was but now it works.

Thank you,
Jürgen

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 22288
    • View Profile
    • Camera Bits, Inc.
Re: Find and Replace does not work
« Reply #3 on: January 05, 2021, 03:17:04 PM »
Jürgen,

I don't understand what the problem was but now it works.

Well, now that's strange.  Please let me know if it happens again and what circumstances cause it to occur.

Thanks,

-Kirk