« previous next »
Pages: [1]   Go Down

Author Topic: PM program starts, but nothing happens  (Read 1196 times)

Offline Martin Froland

  • Newcomer
  • *
  • Posts: 4
    • View Profile
PM program starts, but nothing happens
« on: July 19, 2021, 05:16:33 AM »
Hi. My Photomecanics Plus 6.0.0.5820 Windows version is suddenly not opening user interface. The program starts, Windows Task manager show it is running, but no userinterface shows up.
Logged

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 24756
    • View Profile
    • Camera Bits, Inc.
Re: PM program starts, but nothing happens
« Reply #1 on: July 19, 2021, 07:54:40 AM »
Quote from: Martin Froland on July 19, 2021, 05:16:33 AM
Hi. My Photomecanics Plus 6.0.0.5820 Windows version is suddenly not opening user interface. The program starts, Windows Task manager show it is running, but no userinterface shows up.

For a problem like this, I suggest contacting our support folks at:

By email: support@camerabits.com

By phone: +1 503.547.2888

Hours: Mon-Fri, 9:00am-5:00pm [PST/PDT]
Logged

Offline Martin Froland

  • Newcomer
  • *
  • Posts: 4
    • View Profile
Re: PM program starts, but nothing happens
« Reply #2 on: July 19, 2021, 10:16:26 AM »
OK thanks.
BTW i ended up fixing the problem by detatch the external monitor, reboot once more (did it several times) - and then PM UI showed up. But in the "view" pane, I everything was unchecked. After fixing that, PM runs normal again.
Logged
Pages: [1]   Go Up
« previous next »