Author Topic: PM5b3 IPTC Staionary pad will not Save or Snapshot  (Read 2383 times)

Offline ajmast

  • Member
  • **
  • Posts: 51
    • View Profile
PM5b3 IPTC Staionary pad will not Save or Snapshot
« on: July 14, 2012, 12:37:29 PM »
Win 7, 64b, PM5b3

When I save a Snapshot via the lighting bolt of a stationary pad it will only load blank from the snap shot on the next time I try to apply it. No fields filled in, no fields checked off.

If I save a new XMP file from the stationary pad it lets me name it and click save, closes the dialogue, but never writes out the file. I beleive this is new to b3, as I did the same process in b2 yesterday without incident.

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 24730
    • View Profile
    • Camera Bits, Inc.
Re: PM5b3 IPTC Staionary pad will not Save or Snapshot
« Reply #1 on: July 20, 2012, 11:17:21 AM »
AJ,

We never were able to reproduce your issue.  No issues saving IPTC as XMP or as a snapshot.

-Kirk