Author Topic: Watermarking Logos  (Read 1874 times)

Offline grosda

  • Newcomer
  • *
  • Posts: 10
    • View Profile
Watermarking Logos
« on: April 13, 2013, 12:19:00 PM »
Friends,

I've been experimenting with watermarking with a .png logo generated in photoshop.  I'm applying the logo in Save As along with scaling the image.  The text elements in the logo are getting jaggies, so I was wondering the following:

- should I perform different steps to add the watermark?
- any suggestions on the sizing or preparation of the .png file?

Regards,

grosda

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 21953
    • View Profile
    • Camera Bits, Inc.
Re: Watermarking Logos
« Reply #1 on: April 13, 2013, 03:54:44 PM »
Friends,

I've been experimenting with watermarking with a .png logo generated in photoshop.  I'm applying the logo in Save As along with scaling the image.  The text elements in the logo are getting jaggies, so I was wondering the following:

- should I perform different steps to add the watermark?
- any suggestions on the sizing or preparation of the .png file?

It sounds like you have chosen either one of the corner or edge positions, or are putting your logo image in the center but choosing one of the scaling operations.  If the logo image gets scaled up, it will most certainly get 'jaggies'.

http://wiki.camerabits.com/en/index.php?title=User_Manual_Flat_View#Watermarking

-Kirk