« previous next »
Pages: [1]   Go Down

Author Topic: Locate existing catalogue  (Read 185 times)

Offline Bob M

  • Full Member
  • ***
  • Posts: 159
    • View Profile
    • The McElroys of Point Alexander
Locate existing catalogue
« on: February 13, 2025, 07:11:44 AM »
What are some of thee circumstances that can cause PM+ (7312) to "forget" the location of an existing catalog?  It doesn't happen that often, but it's a bit of a nuisance when it does.  And I may not notice it for quite a while; in the interim I'm busily adding item to the "Default Catalog" rather than my working catalog.

I wouldn't think that remembering a location should be all that difficult.  Is this characteristic of not restarting PM+ very often? ... not shutting down cleanly? sleeping my computer rather than restarting it?  or ... ?
« Last Edit: February 13, 2025, 08:50:39 AM by Bob M »
Logged

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 25175
    • View Profile
    • Camera Bits, Inc.
Re: Locate existing catalogue
« Reply #1 on: February 13, 2025, 02:23:01 PM »
Bob,

Damage to the catalog state database would certainly cause that.  This would most likely be caused by either a forced termination of the application while it is updating that database, or if the application were to crash while updating that database.

-Kirk
Logged
Pages: [1]   Go Up
« previous next »