« previous next »
Pages: [1]   Go Down

Author Topic: Can't open program  (Read 3797 times)

Offline rstukenberg

  • Newcomer
  • *
  • Posts: 2
    • View Profile
Can't open program
« on: January 08, 2014, 04:40:24 PM »
I am running PM 5 on a windows 7 laptop. I think it is the latest build, but it could be the one before. When I try to open the program, I instantly get an error message stating that the file "mfc100u.dll" cannot be found. I did a search and found the file in Windows/system32 folder. It recommends reloading the program, but I do not have a hard copy of the program, since I upgraded from v 4.6.8 online.

Can I move the file to a different folder, or where can I download the program again?
Thanks!
Logged

Offline Brandon

  • Member
  • **
  • Posts: 85
    • View Profile
Re: Can't open program
« Reply #1 on: January 08, 2014, 05:59:53 PM »
You can download 4.6.9 from http://www.camerabits.com/downloads

If the installer has trouble writing to the system folder then try right-clicking on PMSetup4.6.9.exe and choose "Run As Administrator"
Logged

Offline rstukenberg

  • Newcomer
  • *
  • Posts: 2
    • View Profile
Re: Can't open program
« Reply #2 on: January 10, 2014, 01:18:19 PM »
OK thanks. Can I update to PM5 from there?
Logged

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 25020
    • View Profile
    • Camera Bits, Inc.
Re: Can't open program
« Reply #3 on: January 10, 2014, 01:53:17 PM »
It sounds like you have already upgraded your license to PM 5 so make sure you run the Photo Mechanic 5 installer which you can download here:

 http://www.camerabits.com/downloads

If it doesn't install correctly, run the installer as Administrator (like in the post above) and it should be able to install what it needs in order to run on your system.

-Kirk
 
Logged
Pages: [1]   Go Up
« previous next »