Photo Mechanic > Support
NX2 & Color Class is one colour out!
(1/1)
gnomus:
I am using PM 4.5.3.2, Windows Vista and NX2.0.1. NX2 recognizes the stars and the fact that I have applied a colour class. However, the colour is always "one colour out". By that I mean that if I select Green in PM, NX2 shows it as Cyan (with the number 5 in the middle). NX2 consistently shows the next colour up (Orange goes to Yellow, etc).
Is there an easy fix to this? Have I done something stupid (again)?
Thanks in anticipation of your assistance.
Kirk Baker:
--- Quote from: gnomus on September 01, 2008, 08:30:32 AM ---I am using PM 4.5.3.2, Windows Vista and NX2.0.1. NX2 recognizes the stars and the fact that I have applied a colour class. However, the colour is always "one colour out". By that I mean that if I select Green in PM, NX2 shows it as Cyan (with the number 5 in the middle). NX2 consistently shows the next colour up (Orange goes to Yellow, etc).
Is there an easy fix to this? Have I done something stupid (again)?
--- End quote ---
You need to setup Photo Mechanic's Color Class colors to match the colors used in NX2 (same order, same colors, same names.)
-Kirk
Navigation
[0] Message Index
Go to full version