« previous next »
Pages: [1]   Go Down

Author Topic: Burner Set variable question  (Read 3187 times)

Offline Alan

  • Newcomer
  • *
  • Posts: 35
    • View Profile
Burner Set variable question
« on: November 15, 2012, 06:58:03 AM »
Hi,

I am running Photo Mechanic version 5, build 13444 on Windows 7x64.

When I start a 'Burn Photos to Disc' session, the {seqn} variable always defaults to '001'. I can't change the starting {seqn} number. I can set the number in the 'Set {seqn} variable...' window but this change is not reflected on the main screen or in the disk name after burning. Am I missing something or is this correct behavior?

Also scanning through the forum it appears that PM does not support Blu-Ray. Is this correct?

Cheers,
Alan
Logged

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 25020
    • View Profile
    • Camera Bits, Inc.
Re: Burner Set variable question
« Reply #1 on: November 15, 2012, 07:23:30 AM »
Alan,

Quote from: Alan on November 15, 2012, 06:58:03 AM
When I start a 'Burn Photos to Disc' session, the {seqn} variable always defaults to '001'. I can't change the starting {seqn} number. I can set the number in the 'Set {seqn} variable...' window but this change is not reflected on the main screen or in the disk name after burning. Am I missing something or is this correct behavior?

I'll have to look into it and get back to you.

Quote from: Alan
Also scanning through the forum it appears that PM does not support Blu-Ray. Is this correct?

Correct.

-Kirk
Logged
Pages: [1]   Go Up
« previous next »