« previous next »
Pages: [1]   Go Down

Author Topic: Sequence number pattern  (Read 3126 times)

Offline ELB

  • Newcomer
  • *
  • Posts: 1
    • View Profile
Sequence number pattern
« on: November 18, 2007, 05:15:17 PM »
How do I change the sequence number pattern after I have ingested a large number of photo's?
I initially set the sequence pattern to 001, but subsequently ingested over 1000 photo's into two locations. Now the sequence numbers over 1000 are intermixed with those below 1000.  How do I batch modify these lower numbers without starting the whole ingest process over again?
Logged

Offline Kirk Baker

  • Senior Software Engineer
  • Camera Bits Staff
  • Superhero Member
  • *****
  • Posts: 25020
    • View Profile
    • Camera Bits, Inc.
Re: Sequence number pattern
« Reply #1 on: November 18, 2007, 07:05:09 PM »
Quote from: ELB on November 18, 2007, 05:15:17 PM
How do I change the sequence number pattern after I have ingested a large number of photo's?
I initially set the sequence pattern to 001, but subsequently ingested over 1000 photo's into two locations. Now the sequence numbers over 1000 are intermixed with those below 1000.  How do I batch modify these lower numbers without starting the whole ingest process over again?

There is no way to change the sequence numbers used after the fact.  You could use the Rename command to rename them with a new sequence number.

HTH,

-Kirk
Logged
Pages: [1]   Go Up
« previous next »